Regretfully Just Add Sharks Ltd has closed at the end of September 2017. Over the last year Just Add Sharks Ltd has faced challenges with the vanillabox crowdfunded Open Source laser cutter project and with leads times from their suppliers. Demand for low cost laser cutters has outstriped the supply. Lack of timely supply causes delays and disappointments to customers. This is further exasperated by the drop and fluctuating value of pounds sterling. Just Add Sharks Ltd will honour all customers manufacturers warranties.

Customers should continue to email their requests for technical support, software support, spare parts and warranty enquiries to info@justaddsharks.co.uk or using the contact form below.

Removing Residue From Wood

If you've ever used your laser cutter to engrave or cut wood, then you'll be used to the sticky, charred residue that can be left behind. The people at Epilogue Laser have found a solvent free method for removing those stains!

The method is pretty simple! Apply some Permatex Fast Orange hand wash and scrub with a soft bristled brush. Once the staining has lifted, wipe off the remaining residue with a damp cloth. We have some Swarfega Orange here in the office which looks to be the same, perhaps we'll have a play!

Head on over to the Epilogue support page to get the low-down.

« Planetary GearsWe're On Youtube! »

  • 3rd November 2016
  • Kirsty

Postal Address

Company Reg: 08830095
VAT Number: 199319457